In the GY06 controller from year of manufacture 2022 of your transfer presses, you can set the signal tone that announces the end of the countdown to three different levels. To do this, you must go to the factory settings. You can get there by holding the OK key for 5-7 seconds.




The first menu item is P1, here the temperature offset can be set. 



Pressing the OK key again briefly takes you to P2, where the heating behavior of the press can be controlled up to the set temperature.



Pressing the OK button again briefly takes you to Pb, where you can now use the arrow keys to select the three available modes:

  1. At Pb 02 the signal tone sounds with expiration of the time  
  2. With Pb 01, the signal tone sounds 3 seconds before the time expires  
  3. With Pb 00 there is no beep, we strongly advise against this selection, use it only when the machine is supervised at all times.



Pressing the OK key again briefly takes you to the Cnt area, where the non-resettable counter is located.




Pressing the OK key briefly again takes you to the ANT area, where the operating hours and operating minutes are counted.




Pressing the OK key briefly again takes you back to the main menu.